Blog
Page 55 of 59

Replacing Manual Test Calls on a LiveKit or Pipecat Agent: How to Automate Voice Agent Testing With a Small Team
Break a 30-minute manual test call session into 16 checks, then automate them in four layers on LiveKit or Pipecat, with cost math and flake control.

Voice Agent Prompt Versioning: Shipping Prompt and Flow Changes to an In-House Voice Agent Without Breaking Live Calls
Voice agent prompt versioning for LiveKit and Pipecat: pin each call to a release, gate on pass^k, size the canary, and roll back without dropping calls.

Deepgram Flux vs Nova-3 for Voice Agents: Accuracy, Turn Detection, Latency and Cost
Flux or Nova-3 for a phone voice agent? Verified features, pricing at 50k to 500k calls, what each latency number means, and a bake-off you can run.

LiveKit Call Recording and Pipecat Audio Recording: Stereo Recordings, Egress and Per-Call Metrics
Record LiveKit and Pipecat calls in stereo: Egress channel routing, AudioBufferProcessor, Twilio dual-channel, clock alignment, storage math, metric code.

Running LiveKit Agents on Kubernetes: Scaling, Draining Calls and Safe Releases
LiveKit agent Kubernetes guide: how agent servers decide they're full, cgroup load traps, drain math for live calls, job-based autoscaling, safe canaries.

LiveKit Noise Cancellation Self-Hosted: Krisp, BVC, AEC and How to Test Them
What runs on self-hosted LiveKit for noise and echo: Krisp, BVC, open-source filters, AEC warmup, and a test plan with SNR beds, WER and barge-in rates.

Measuring Pipecat Latency Stage by Stage: Metrics, Observers and the Numbers That Lie
Measure Pipecat latency stage by stage: what each TTFB times, how UserBotLatencyObserver splits a turn, and how to check it against a call recording.

Deepgram Flux vs Silero VAD vs a Turn-Detector Model: Which End of Turn Detection Voice Agent Method to Use
Silence timers, Deepgram Flux, LiveKit and Smart Turn models, and semantic VAD compared: defaults, published benchmarks, the stacking trap, and a test.

LiveKit Transfer Call and Pipecat Handoff Guide: Ending Calls, Warm vs Cold Transfer, SIP REFER vs Bridge
How to end, cold-transfer and warm-transfer calls in LiveKit and Pipecat: SIP REFER vs bridge, real per-minute costs, failure modes and a test matrix.